Witches Hat Treat Holder

SUPPLIES: basic black cs, bonefolder, paper cutter/scorer, frightful sight dsp, stampin' glitter I used olive, 2-way glue pen, curly label punch, 1-1/4''striped grosgrain ribbon
______________________________________

This is so adorable and of yes super easy. I am defiantly making these treat holders for my sons class this year. Hope you enjoy!

Cut a 11-1/2 X 4

fold down the center, then open back up

take your ruler and score from center fold down to 2'' over
(which is center of cs)

now it should fold like this on each end

cut this piece at 1''X7''

to create your witches brim
trim from bottom corner up to your 2'' mark (do this on both sides.)

take your crop a dile the 3/16 side punch hole to weave the ribbon through

apply the brim to hat

cut another piece at 3/4'' X 3-1/2 ( you will trim off any extra)

punch out one using the curly label punch

take your glue smear evenly on to punch out, then apply glitter

trim hang off paper

after attaching the curly label punch I cut off a small square to put in the middle
(you can see n the picture below)
to get the shredded ribbon look I used my scissors and really
tour tugged and ripped.

before you tie her off, add your favorite spooky candy and
BAM you have a cool e o witches hat.